6 Installation
Operating and Installation Instructions UL 48
4.
Carefully tilt the unit on one side.
Warning: Risk of unit falling down!
Make sure that the two pins on the center adapter correctly
engage the corresponding holes at the bottom of the unit.
Remove the two styrofoam blocks on this side.
5.
Use the enclosed hex screws to attach the top unit to the center
adapter at the place where the front foot and rear foot (on the
side that is not up in the air) would normally be.
Do not tighten the screws yet.
6.
Remove the two styrofoam blocks (1) on the other side of the
unit and set the unit down.
Secure the unit on the other side.
Use the enclosed hex screws (2) to attach the top unit to the
center adapter at the place where the front foot and rear foot
would normally be.
Use an open-end wrench with a width across flats of 13 mm.
7.
Tighten the two screws that are still loose on both feet at the
other side of the unit.
To Next Page
Loading...
Need help?
General
