3.
Cut the fastener holding the stretch plastic.
4.
Remove all the corner pieces one at a time by lifting up
the top cover briefly at each corner.
Then take the top cover off completely.
Remove the customer documentation from the top of
the appliance.
5.
Undo the screw fastenings on the slides and pull the slides
out. Keep the screws and slides to hand.
Additional information:
The slides will be used as a ramp for the appliance.
7.
Inspect the appliance again for damage.
If you suspect the appliance has been damaged during
transit, notify your dealer/carrier immediately. Please notify
the manufacturer in writing within three days.
Never install or put into service a damaged appliance un‐
der any circumstances.
5 Setting up the appliance
Installation manual 57
To Next Page
Loading...
Need help?
General
