6.3.3 Testing the water quality
Materials required
You will need the following materials:
1 sample container for taking samples
1 conductivity meter (part no. 3019007)
Analysis kit for measuring general hardness and carbonate hardness, including two analysis con‐
tainers (part no. 3019010)
Protective gloves
Test the water quality
Measure the electrical conductivity and general hardness of the water by following the instructions in‐
cluded with the tester and analysis kit.
Compare the measured values with the recommended values listed under the '
Water quality
on page
131' heading in the
'Technical data'
on page 111 chapter.
6 Installation
Installation manual 92
To Next Page
Loading...
