5.6 Setting up a table-top unit on a work surface
Rules for setting up the appliance safely
Observe the following rules to ensure that the appliance is installed in a stable situation:
It must be possible to set up the work surface in the installation position so that it cannot tip over or
slide about. The supporting surface must comply with the requirements.
The work top must have a non-slip surface. If necessary, place non-slip pads under the appliance
feet (pads available from manufacturer).
If you intend to load the combi steamer using transport trolleys, the appliance must be installed at
the same height as the loading height of the transport trolley. The roll-in frame inserted in the cook‐
ing chamber and the surface on which the mobile shelf rack sits on the transport trolley must be at
the same height when the transport trolley is attached to the combi steamer.
It must be possible to wheel the transport trolley up to the cooking chamber and to fix it to the roll-in
frame on a horizontal surface that is clear of obstructions.
Setting up the appliance on a work surface
1.
Position the appliance on the work surface.
2.
Remove the cover from the appliance foot.
5 Setting up the appliance
Installation manual 61
To Next Page
Loading...
Need help?
General
