5.9 Setting up a floor-standing unit on the floor
Rules for setting up the appliance safely
Observe the following rules to ensure that the appliance is installed in a stable situation:
It must be possible to set up the appliance in the installation position so that it cannot tip over or
slide about. The supporting surface must satisfy the requirements listed below.
Setting up the appliance
1.
Position the appliance on the floor.
2.
Ensure the appliance is horizontal by adjusting the height
of the appliance feet.
Use a spirit level to ensure the unit is horizontal in all di‐
rections.
Make sure that the loading trolley can move freely into the
appliance and stands horizontally in the appliance.
The absolute tilt of the appliance in operation must not
exceed 2° (3.4%).
5 Setting up the appliance
Installation manual 68
To Next Page
Loading...
Need help?
General
