5.7 Setting up a table-top unit on a stand
Rules for setting up the appliance safely
Observe the following rules to ensure that the appliance is installed in a stable situation:
It must be possible to set up the stand in the installation position so that it cannot tip over or slide
about. The supporting surface must comply with the requirements.
If you intend to load the combi steamer using transport trolleys, the appliance must be installed at
the same height as the loading height of the transport trolley. This is automatically the case if the
surface for wheeling up the transport trolley lies at the same level as the surface for on which the
combi steamer stand is installed.
Setting up the appliance on a stand
1.
Screw the threaded bolts into the threaded holes provided
in the oven stand and tighten the threaded bolts with the
screwdriver.
2.
Position the appliance on the stand.
Make sure that all four bolts are guided into the locating
holes in the appliance feet provided for the purpose.
5 Setting up the appliance
Installation manual 63
To Next Page
Loading...
Need help?
General
