12 1/12
Clean Blended Ice Machine (BIM-8)
Weekly BE 23 W1
©McDonald’s Corporation · Planned Maintenance Manual · October 2011 Page 1 of 5
Blended Ice Machine Models MS-8-1H, MS-8-1LH, MS-8-EH, MS-8-ELH, MS-8-BH, MS-8-BLH, MS-8-CH, MS-8-CLH, MS000A03, MS000A04
Weekly BE 23 W1
Why
To break the bacteria cycle
Time required
10 minutes to prepare 50 minutes to complete
Time of day
At close For 24-hour restaurants: During low-volume periods
Hazard icons
Precaution:
Hazard Communication Standard (HCS) – The procedures on this card include the use of chemical products.
These chemical products will be highlighted with bold face letters followed by the abbreviation (HCS) in the
tools portion of the procedure. See the Hazard Communication Standard (HCS) manual for the appropriate
Material Safety Data Sheet(s) (MSDS).
Tools and supplies
Cleaning Pitcher Cleaning Tubes Bucket with SolidSense All
Purpose Super Concentrate
(APSC)
Bucket with 2 KAY 5
Sanitizer (HCS) packet
Bucket with rinse water Bio-Shield Dispenser Bio-Shield Tower Drain
Cleaner
Bucket, clean,
sanitizer-soaked towels
Bucket, soiled towels KAY 5 Sanitizer Solution Scoop Empty bucket KAY Beverage Equipment
Cleaner
Taylor Lube HP or
Carpigiani Carpilube
Procedure
1
Cycle touch pad to cleaning.
On the Menu screen press
Cleaning, then Weekly
Cleaning.
2
Gather items shown.
3
Empty ice hopper.
Remove ice hopper lid. Use
an ice scoop and an empty
bucket to remove as much ice
as possible from above the ice
shelf. Replace ice hopper lid.
4
Manually dispense ice.
Place a blend pitcher on the
pitcher pad. Press Manual Ice
Dispense button until ice
hopper is empty. Remove
blender pitcher of ice and
discard in back sink.
5
Fill each labeled bucket to the
fill line with the appropriate
solution and bring to machine.
Fill APSC bucket with hot
SolidSense APSC from
dispenser at 3-compartment
sink.
Fill RINSE bucket with
warm, clean water.
Fill SANITIZE bucket with 5
gallons of lukewarm water
and 2 packets of
KAY 5
Sanitizer and mix thoroughly.
Electricity
Chemicals
Sharp Objects/Surfaces
continued X
To Next Page
Loading...
Need help?
General