26 1/12
Centering Scale Instructions
1. Remove drive coupler.
2. Loosen plate.
3. Center drive coupler to plate.
4. Tighten plate screws.
Manager’s Menu Screen
After selecting Managers Menu, the pass code
screen appears.
Managers password is 3312 or 71360.
The screen features:
• Upload New Menu and Recipe Data
• F/C Temperature Units
• Update System Parameters
- Date and Time Settings
- Refrigeration Settings
- Valid Weight Ranges
- Specifi c Product Settings
- Ice Dispense Settings
- Water Dispense Settings
- Cleaning Process Settings
- Service Intervals
- Return
• Return
Reset functions password is 93078.
The screen features:
• Reset Inventory
• Reset Hardware History
• Reset Date of Manufacture
• Reset System Parameters
• Reset Born on Date
• Reset Cleaning Timer
Service password is 89531.
The screen features:
• Update System Parameters
• Scale Calibration
• Periodic Maintenance
• Fault and Diagnostic History
• Input/Output Test
• Smart Equipment Commission
• Return
Factory Service password is 54221.
The screen features:
• Asset and Operation History
• System Parameters
• Blender Motor Replaced
• Shaver Motor Replaced
• Blender Spindle Replaced
• Blender Control Replaced
• Blender Control Fan Replaced
• Scale Beam Replaced
• Compressor Replaced
• Install New Firmware
• Return
To Next Page
Loading...
