18 1/12
Procedure to Replace a Product Bag
These instructions can be found on the Touch Screen in
the Help Menu under “Replace Product”.
1. Touchscreen will indicate the bag is empty “Drink
making paused, check product supply”.
2. Press “Replace product”.
3. Use the arrows and the Confi rm button to select the
product to be replaced.
4. Remove product bin from cabinet and discard
empty bag.
5. Wipe the inside of the product bin with a clean
sanitize towel.
6. Place bag in product bin with spout down. Position
product bag with the spout facing down. Position
the rear groove of the spout on the product bag
into the front slot of the product bin. Make sure it’s
properly snapped into place.
7. Open the cap on the product bag and tear it off.
8. Return product bin to its position in cabinet.
9. Press OK on touchscreen panel. This will reset
inventory.
10. Procedure complete. Use the arrows and the
Confi rm button to select another product to be
replaced. Press Return to display the previously
active screen.
To Next Page
Loading...
Need help?
General