Manitowoc National Crane NBT30H-2 User Manual

CONTROLS AND OPERATING PROCEDURES NBT30H-2 OPERATOR MANUAL
3-22
Published 03-18-2019 Control # 582-04
Delete All Limits
RCL Limit #6
The RCL Limit #6 screen will allow the operator to select and
delete all limit values that exist.
- Select Trash Can to delete all values.
- The Escape function goes back to the Main
Limits menu screen without deleting any limit
values.
TOOLS
Main Menu
Select function key #2, Tools Menu on the MAIN Menu
screen.
Tools Screen
The Tool Screen will contain the following set up, calibration,
tools and measurement display information.
Each selection on the Tools Screen is made by using the
arrow keys to scroll and make the selection; press Select
button to accept the selection.
• Units of Measure
Yellow indicates the currently set value.
• RCL Sensor Calibration - Sensor calibration is
password protected, refer to the Service Manual.
• Hydraulic Filter Reminder Setup - ON/
OFF, reminder interval (40/250/500 hr.), reset reminder.
This display allows the operator to setup a reminder to
check/replace the hydraulic return and suction filter on
the crane. The operator can select three different
intervals. When the timer expires, an indicator is turned
on for the operator to indicate it is time to change the
filter. To reset the timer select the far right icon.
• Screen Brightness - Allows adjustment of
backlight over a range of 15 steps.
• Up and down arrows in the time and password boxes
correspond to button #1 selection.
• Light GRAY background box highlights BLUE when
selected, starts in upper left corner.
8717-15
FIGURE 3-22
8717-2
RCL Tools Diagnostics
FIGURE 3-23
Temperature, select either °F
(Fahrenheit) or °C (Celsius)
Length, select either ft (feet) or m
(meter)
Weight, select either lbs (pounds) or
kg (kilograms)
8717-16

Manitowoc National Crane NBT30H-2 Specifications

General

Brand	Manitowoc
Model	National Crane NBT30H-2
Category	Construction Equipment
Language	English