MODEL YB8 INSTALLATION AND OPERATION
April 1999/Manning Environmental Inc.
Page A-11
Figure 16 - Distribution Assembly Picture
2. Place the distribution assembly on the suspension plate with the plate handles poking through
the slots in the distribution assembly.
3. Insert the discharge tube into the upper union. The discharge tube must be flush against the
union to prevent leaking.
4. Mate the black connectors. ( Applying non-conductive grease will help if d isassembly
is required later.)
There are wire racks inside the refrigerator so the distribution assembly can be parked out of the way when
removing the suspension plate and/or bottles. This makes it unnecessary to remove the discharge tube from
the spout union or to de-mate the connector when removing the plate.
To Next Page
Loading...