PROGRAMMING SECTION MODEL YB8
April 1999/Manning Environmental
3DJH%
Utility & Display Functions
Key Function
<RESET>
Functions as a Reset (a soft boot in computer terms) for the sampler and clears
the current program mode.
<TEST CYCLE>
Allows the user to check the sampler for mechanical operation by taking a
physical sample.
<BOTTLE ADV>
Advances the spout clockwise 1 bottle each time the key is pressed. This
function will not work when a program is running.
<CLEAR>
Clears invalid and incorrect entries before <ENTER> has been pressed. Also
allows the user to step the cursor back 1 movement, clearing entries each time
the key is pressed.
<CLOCK>
Sets the time and date. To set, press RESET twice, press CLOCK, enter the
time and date and then press <ENTER>. NOTE: All times are entered and
displayed in 24 hour HH:MM format. For example, 6 hours would be entered as
0600 and a real time of 3:30 p.m. would be displayed as 15:30.
<DISPLAY>
Shows current program o r configuration information. T he information displayed
depends on whether the user is in or out of a programmed mode. If the user is
out o f a programmed mo de, pressing <DISPLAY> will show the configuration
settings input in *99. If the user is in a programmed mode (e.g. a TIME, FLOW,
or * Mode), pressing <DISPLAY> will show the current t ime, spout position,
and other information specific to the current mode. NOTE: See Appendix B for
a Logic Map o f t he Programming Modes and what displays are active when t he
Display key is pressed.
*
Used to program Star Modes.
EEEE
Indicates an error condition has occurred. Press CLEAR to reset, and re-enter
the data.
Key Not Active I
ndicates the key pressed is not active at the current time.
To Next Page
Loading...