MODEL YB8 INSTALLATION AND OPERATION
April 1999/Manning Environmental Inc.
Page A-19
B) Wire the white (+) and green (-) wires to the external device’s analog output.
C) Re-connect the cable to the "Contact/Analog In" connector.
This should complete the installation of the contact closure. Test the connection through the external device
to verify the wiring is correct and the sampler is initiating a sampling cycle when the signal is received. See
the *08 Mode in the Programming section fo r additional information.
This completes the installation of the sampler. The unit should now be operational. Proceed to the
programming instructions t o program t he sampler fo r operation.
To Next Page
Loading...