PROGRAMMING SECTION MODEL YB8
April 1999/Manning Environmental Inc.
3DJH%
BACKLIGHT MODE?
__ 04:30:02
Sets whether the display backlights:
0 - Backlight is never on. T his is good if p ower conversation is
critical.
1 - Backlight comes o n when a key is pressed. T he light will
automatically turn off after 30 seconds if another key is not
pressed.
2- Backlight comes on when a key is pressed and also at the start of
a sampling cycle. T he light will automatically t urn o ff after 30
seconds if another key is not pressed or another sampling cycle is
not initiated.
3- Backlight is always o n. T his choice will quickly run down a
battery.
ENTER PASSWORD
__ __ __ __ 04:30:02
Creates a password to stop unauthorized access. There are 2
options:
A. Press <ENTER> to accept no password - 0000 (default
shown)
B. Enter a 4-digit number at the prompt and press <ENTER>.
The user will be prompted t o verify t he password. E nter the
same 4 digits and press <ENTER>. This sets the password.
RECORD the numbers. To change a password, enter *99
mode and input the 4 digit numeric password at the
PASSWORD PROTECTION prompt. Press <ENTER>.
The user can now go into *99 and at the ENTER
PASSWORD prompt, create a new password.
Note: Use a TEST CYCLE setting of 0 if TEST CYCLE is to be
password protected while a program is running.
If the password is forgotten, call the Manning Service Department at
(800)-863-9337.
After finishing the Configuration Mode, t he sampler will return to the Sampler Ready prompt and the current
time will be displayed. C onfiguration is now complete, and t he sampler is ready fo r programming.
To Next Page
Loading...