Marantz NR1403 - Remote Lock Function

52
Panel lock function
n Canceling the Panel lock function
1
Press X ON/STANDBY while you press and hold DISPLAY and M-DAX with the
unit in standby mode.
2
Press PRESET CH + or PRESET CH – to select “FP LOCK zOff”.
(z The currently set mode.)
3
Press STATUS to enter the setting.
The Panel lock function is canceled.
Even when the Panel lock function is set, you can operate the unit using the remote control unit.
Remote lock function
•When not connecting an IR receiver, disable the Remote lock function. When the function is enabled, you
can not perform operations with the remote control unit.
•By default, this function is disabled.
X ON/STANDBY PRESET CH +
DISPLAYM-DAX
STATUS
PRESET CH –
n Disabling the sensor function of the remote control unit
1
When the main unit is in standby mode, press X ON/STANDBY while holding
down DISPLAY and M-DAX on the main unit.
2
Press PRESET CH + or PRESET CH – to select “RC LOCK On”.
(z The currently set mode.)
3
Press STATUS to enter the setting.
The infrared light receiving function is disabled.
n Enabling the remote sensor function
1
When the main unit is in standby mode, press X ON/STANDBY while holding
down DISPLAY and M-DAX on the main unit.
2
Press PRESET CH + or PRESET CH – to select “RC LOCK zOff”.
(z The currently set mode.)
3
Press STATUS to enter the setting.
The infrared light receiving function on the main unit is enabled.