Marantz PM-11S3 User Manual

23
Getting started Basic connections Basic operation Specifications IndexAdvanced connections Advanced operation Explanation terms
ENGLISH
Troubleshooting
Symptom Cause Countermeasure Page
The left and right of stereo
sound is reversed.
tThe connections of the speakers or
input cables are reversed
tCheck the connections to be sure that
left is connected to left, right to right.
7
Humming sound is heard
in the music when playing
turntable.
tThe player’s ground wire is not
connected.
tThe cables are not fully connected to
the PHONO terminals.
tInfluence from a TV or VCR near the
player.
tConnect securely.
tConnect securely.
tTry changing the positions in which the
devices are installed.
9
9
–
Howling is produced along
with the music if the volume
is too high when playing
turntable.
tThe player and speakers are too close
together.
tThe vibrations from the speakers are
being transmitted to the player through
the floor.
tInstall the player and speakers as far
from each other as possible.
tUse cushions, etc., to absorb the
speakers’ vibrations.
–
–
When playing turntable, the
sound is distorted.
tThe needle pressure is incorrect.
tThere is dirt on the tip of the needle.
tThe cartridge is defective.
tAdjust to a proper needle pressure.
tCheck the tip of the needle.
tReplace the cartridge.
–
–
–
The remote control does not
work.
tThe batteries are exhausted.
tThe remote control unit is too far from
the unit.
tThere is an obstacle between the unit
and the remote control unit.
tButton selection was mistaken.
tThe batteries are not loaded with correct
polarity (q, w).
tReplace the batteries with new ones.
tOperate closer to the unit.
tRemove the obstacle.
tConfirm the correct button to press.
tCorrect the direction of the batteries
according the polarity instruction.
2
2
–
–
2
Troubleshooting

Marantz PM-11S3 Specifications

General

Damping factor	100
Amplifier class	-
Frequency range	5 - 100000 Hz
Input sensitivity	240 mV
Audio output channels	2.0 channels
Peak power per channel	200 W
Signal-to-Noise Ratio (SNR)	96 dB
Total Harmonic Distortion (THD)	0.01 %
Dynamic power per channel (8 Ohm)	100 W
XLR in	Yes
Headphone outputs	1
Line inputs (RCA)	2
Headphone connectivity	6.3 mm
Speakers connectivity type	Clamp terminals
Material	Metal
Cooling type	Passive
Product color	Black, Gold
Volume control	Rotary
Connectivity technology	Wired
Power consumption (standby)	0.3 W
Power consumption (typical)	300 W

Weight and Dimensions

Depth	449 mm
Width	440 mm
Height	168 mm
Weight	27000 g