Setting remote control codes for the
remote control
o
To set the remote control codes to AMP1,
AMP2 or AMP3
1
Hold down REMOTE MODE CD and one of the number
1, 2 or 3 buttons for more than 5 seconds.
0
Set the remote control code to AMP1, AMP2 or AMP3 according
to the selected number button.
NOTE
0
The remote control codes returns to the default settings when the batteries are
removed. Set the remote control codes again after replacing the batteries.
Setting remote control codes for the
main unit
1
Point the remote control for which the remote control
code was set at the main unit, and press REMOTE
MODE CD and ENTER.
The input indicators on the main unit flash as shown below
according to the set remote control code.
Remote control
codes
Input indicator
AMP 1 PHONO indicator flashes in red three times
AMP 2 CD indicator flashes in red three times
AMP 3 NETWORK indicator flashes in red three times
Contents Connections Playback Settings Tips Appendix
35
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
