Input source
select buttons
1
Press ZONE2 to switch the zone mode to the ZONE2.
2
Press POWER X to turn on the ZONE2 power.
The ZONE2 power indicator on the display lights (vpage16).
•Also press input source select button when in standby mode, the
power turns on.
•When POWER X is pressed, ZONE2 turns o.
•Power in ZONE2 can be turned on or o by pressing ZONE2 ON/
OFF on the main unit.
3
Press the input source select button to select the input
source to be played.
The audio signal of the selected source is output to ZONE2.
•Turn INPUT SELECTOR after pressing ZONE2 SOURCE on the
main unit to select an input source.
To Next Page
Loading...
