Marantz SR8001 - Mode 3: Update;Download HDMI Cpus Software to Internal Flash-ROM

50
Mode 3: Update/Download HDMI CPU's software to
internal Flash-ROM.
Update/Download software for HDMI CPU (Mode 3)
[M3-1] The writing software setup procedure
1. Launch the Flash Development Toolkit v3.06 (FDT).
NOTE : Please refer to "[A] SOFTWARE (fdtv306r00.exe)
DOWNLOAD AND INSTALL PROCEDURE", when
you do not have FDT.
Can NOT update/download software by
FDT ver.3.3.
2. Click Start, Programs, Renesas, Flash Development
Toolkit 3.06 and Flash Development Toolkit 3.06.
3. Check the Create a new project workspace, and click
the OK.
NOTE : It is needs setup for SR7001/SR8001. When you
have already setup, please advance to "[M3-2]
Writing Procedure for HDMI CPU".
Mode 3: Update/Download HDMI CPU's software
to internal Flash-ROM.
Update/Download software for HDMI CPU (Mode 3)
[M3-1] The writing software setup procedure
1. Flash Development Toolkit v3.06 (FDT)
を起動します。
注意：
FDTを持っていない方は"[A] SOFTWARE (fdtv306r00.
exe) DOWNLOAD AND INSTALL PROCEDURE"
を参
照してダウンロードしてください。
この書き込みはFDT ver.3.3では出来ません。
2. Start, Programs, Renesas, Flash Development
Toolkit 3.06, Flash Development Toolkit 3.06
をクリッ
クします。
3. Create a new project workspace
をチェックし、OKを
クリックします。
注意：
SR7001/SR8001用の設定が必要です。既に設定が終
わっている方は
"[M3-2] Writing Procedure for HDMI
CPU"
へ進んでください。