21
1. Camera Address setting for VISCA protocol: When just one camera is used, system takes the
camera ID address that is set on Bottom DIP Switch. When more than one camera is used,
cameras will be automatically issued ID addresses by system via VISCA protocol. The ID
address setting on Bottom DIP Switch will be ignored by system.
2. Video Color Space
3. Control Setting
In normal use, B6 has to be set to OFF, USB3.0. RS-232, RS-422, RS-485 way of controlling
will be recognized by the camera. B6 ON is only for authorized use.
4. RS-232 / RS-422 Baud Rate Setting
The baud rate of the camera has been set up as 9600bps, it is not changeable.
B1
B4
B6
OFF
OFF
ON
ON (For Authorized Use ONLY)
B7
OFF
ON
OFF
ON
B8
OFF
OFF
ON
ON
RS-232 / RS-422 Baud Rate Setting
9600 bps
9600 bps
9600 bps
9600 bps
Color Space Setting
Control Setting
YUV
For Normal Use
RGB
Firmware Upgrade
ON
OFF
ON
OFF
ON
OFF
ON
B2
OFF
ON
ON
OFF
OFF
ON
ON
B3
OFF
OFF
OFF
ON
ON
ON
ON
Address
1
2
3
4
5
6
7
To Next Page
Loading...
Need help?
General
