Marson mt850 - Chapter 2 General Settings; Barcode Configurability; Factory Default; Check Version

MT850 User’s Manual V1.3
10
Chapter 2 General Settings
Barcode Configurability
Scanning below configuration barcodes will allow/prohibit user to change settings by scanning
configuration barcodes in this manual.
Enable Barcode Configurability*
Disable Barcode Configurability
Factory Default
Scanning below configuration barcode will reset all parameters to factory default settings (the ones
with * asterisk mark)
Factory Default
Check Version
To check firmware version, please scan below configuration barcode.
Check Version