Marson mt850 - Check Device MAC Address; Check Host MAC Address; Scanlink

MT850 User’s Manual V1.3
25
Check Device MAC Address
Check Device MAC Address
Check Host MAC Address
Check Host MAC Address
ScanLink
ScanLink is a connection method that turns the scanner into a master device, which initiates the
Bluetooth connection with the target host device (now a slave device). This, as a result, saves user
the trouble of going through numerous setup procedures on the host device to establish
connection.
Simply generate ScanLink barcode for the target slave device in below rule:
For BT HID profile, please encode:
HID<MAC Address> in Code39 without checksum or QR Code.
For BT SPP profile, please encode:
SPP<MAC Address> in Code39 without checksum or QR Code.
Example: Target Slave Device MAC Address = 00:15:83:52:2C:3B, Profile = BT HID
Encode HID001583522C3B in Code39 without checksum or QR Code.