TC_TYPE? IEEE-488 RS-232 Sequential Overlapped
This command returns the Thermocouple (TC) sensor type being used for TC
temperature source and measurement.
Parameter: <None>
Response: <value>
where <value> is one of the following:
B B-type thermocouple
C C-type thermocouple
E E-type thermocouple
J J-type thermocouple
K K-type thermocouple
L L-type thermocouple
N N-type thermocouple
R R-type thermocouple
S S-type thermocouple
T T-type thermocouple
U U-type thermocouple
XK XK-type thermocouple
BP BP-type thermocouple
Z 1 mV/°C
Example: TC_TYPE?
K
This example indicates that the thermocouple sensor type is K-type.
TSENS_TYPE IEEE-488 RS-232 Sequential Overlapped
This command sets the temperature mode to thermocouple (TC) or Resistance
Temperature Detector (RTD) for temperature source and measurement.
Parameters: <value>
where <value> is one of the following:
TC Thermocouple
RTD Resistance Temperature Detector
Response: <None>
Example: TSENS_TYPE RTD
This example sets the temperature mode to RTD.
XXX
XXX
73
To Next Page
Loading...
