Martin Exterior Projection 500 User Manual

Exterior Projection 500
User Manual

Martin Exterior Projection 500 Specifications

General

Warranty	2 years
Color Temperature	6500K
Control	DMX, RDM
Input Voltage	100-240V AC, 50/60Hz
Color Reproduction	Full RGB spectrum
Operating Temperature	-20°C to 45°C

Summary

Safety Information

Protection from Electric Shock

Details safety precautions regarding electrical hazards and grounding.

Protection from Burns and Fire

Outlines precautions to prevent burns and fire hazards from the fixture's operation.

Protection from Eye Injury

Provides warnings and guidelines to prevent eye damage from the light output.

Protection from Injury

Details safety measures for secure mounting and handling to prevent physical injury.

Physical Installation

Mounting the Fixture

Provides instructions on how to securely mount the fixture for optimal performance.

Anchoring to a Surface or Structure

Details how to securely anchor the fixture's mounting yoke to a surface.

Adjusting Aiming (Pan and Tilt)

Guides users on how to adjust the fixture's pan and tilt for precise beam aiming.

AC Power

Connecting to Power

Details the process and requirements for connecting the fixture to AC power.

Control Data Link

Connecting the Data Link

Provides guidelines for connecting the DMX data link, emphasizing moisture protection.

Fixture Setup

Using the Control Menus

Explains how to access and navigate the fixture's control panel menus and settings.

Setting a DMX Address

Guides on setting the fixture's DMX start address for control.

Programming a Standalone Show

Explains how to program and run standalone shows without a DMX controller.

Manual Control Mode

Details how to enter manual control mode for testing and direct operation.

Manual Test / Manual Single Scene Display

Fixture Configuration (Including Master/Slave Operation)

Covers settings for customizing fixture behavior, including master/slave synchronization.

Setting Up Master/Slave Operation

Provides step-by-step instructions for configuring master/slave synchronization.

Offline Mode – Behavior When No DMX or Master Signal is Received

Setup via RDM

Explains how to use RDM for remote configuration and data retrieval.

Effects

Strobe / Shutter

Electronic Dimming

Color Wheel

Gobos

Describes the rotating gobo wheel with six interchangeable glass gobos.

Focus

Maintenance

Cleaning

Provides guidelines for cleaning the fixture's housing and optical components.

Managing Humidity

Removing Humidity Using Evaporation Mode and Silica Gel Desiccant

Removing and Reinstalling the Top Cover

Provides detailed instructions for safely removing and reattaching the fixture's top cover.

Updating Firmware

Setting Beam Angles When Updating Firmware

DMX Protocol

Control Menus

DMX Address

Menu option to set the fixture's DMX address.

Program Show

Fixture Config

Troubleshooting

Specifications

Physical

Dynamic Effects

Lists the fixture's dynamic lighting effects and features.

Control and Programming

Specifies control systems, DMX channels, and protocol compliance.

Optics

Photometric Data

Provides output and intensity data for different beam angle models.

Construction

Gobos

Connections

Electrical

Specifies electrical power supply, current, and surge protection details.

Thermal

Photobiological Safety Warning

Highlights the risk group classification and potential optical radiation hazards.