16 MAC 2000 Wash
5 To calibrate the dimmer, select UTIL/CAL/D OF and press [Enter]. Hold a piece of paper over the
lens. Set the offset to 0 and then increase it until light is clearly projected onto the paper. Press [Enter] to
save the setting. Remove the paper.
6 To calibrate color mixing flags (cyan, magenta, yellow, and color temperature correction), project white
beams with no dimming and position them for easy comparison. On each fixture, including the reference,
select
UTIL/CAL/C OF and press [Enter]. (This adds a defined amount of cyan.) Select one fixture to
be the reference. Adjust the offsets on the other fixtures to match the reference color. Press [Enter] to save
the setting. Repeat for
M OF (magenta), Y OF (yellow), and CTOF (CTC).
7 Focus calibration is useful when two or more fixtures are the same distance from a projection surface. To
calibrate focus, set up all fixtures with the same focus, zoom, dimming, and gobo values. Select a focussed
fixture to be the reference. On the other fixtures, select
UTIL/CAL/FOOF and press [Enter]. Adjust the
offset to focus the image. Press [Enter] to save the setting.
SOFTWARE UPLOAD
The software update mode is normally engaged automatically by the upload device.
To Next Page
Loading...
