To Next PageTo Next Page
Need help?Do you have a question about the Martin MAC 600 and is the answer not in the manual?
Covers manual content, software versions, and where to find updates.
Details risks (shock, UV, fire, falls) and necessary precautions for safe operation.
Lists package contents and emphasizes using original packing for transport.
Step-by-step guide for safely installing or replacing the fixture's lamp.
Covers checking voltage/frequency settings and grounding for safe AC power connection.
Instructions for safely mounting the fixture on a truss or stage using clamps and safety cables.
Tips for building a reliable RS-485 serial link, cable types, and termination.
Explains connecting multiple fixtures via XLR and DMX/Martin protocols, including cable types.
Guides on selecting DMX/Martin protocol and assigning start addresses for fixture control.
Instructions for attaching the optional snoot accessory to the fixture.
Details controlling the fixture using Martin RS-485 protocol and compatible controllers.
Explains DMX control modes (tracking, vector) and resolution settings.
Covers automatic lamp-on, DMX lamp-off, and reduced power mode for lamp operation.
Describes pan, tilt, color wheel, CMY mixing, beam shapers, dimmer, and shutter effects.
How to set the DMX or Martin address and select the control protocol using the control panel.
Details various personality settings for customizing fixture behavior like speed, feedback, and display.
Explains how to access usage, DMX values, software version, and temperature readouts.
Describes manual operation of fixture functions like reset, lamp, shutter, dimmer, and effects.
Outlines running general tests, circuit board tests, and factory tests for diagnostics.
Covers calibration, resetting defaults, and saving custom configurations for the fixture.
Step-by-step guide to safely remove the printed circuit board from the fixture.
Instructions for reinserting the circuit board and reconnecting wire connectors.
Details locating and replacing primary and secondary fuses for fixture repair.
How to modify the XLR pin-out configuration using jumpers on the circuit board.
Instructions for attaching and removing optional lens hoods for beam angle adjustment.
Procedures for cleaning optical components like lenses and filters using specific cleaning agents.
Explains the importance of fan cleaning for cooling and how to perform it.
Steps for replacing the lamp and resetting lamp hour/strike counters.
Guide on adjusting lamp position for even light distribution using adjustment screws.
How to adjust internal settings for different AC power supply voltages and frequencies.
Standard procedure for updating fixture software remotely using an upload device.
Guide to performing software updates when the fixture is in boot mode or if data is corrupted.
Detailed breakdown of DMX channels, values, percentages, and their corresponding functions.
Lists error messages, their causes, and recommended actions for troubleshooting.
Common issues, probable causes, and remedies for fixture malfunctions.
Diagram of the main circuit board with labels for components and connectors.
Physical dimensions and weight specifications for the MAC 600/E fixture.
Electrical data including ballast taps, power, current, and power factor for magnetic ballast models.
Electrical data for electronic ballast models, including transformer taps, power, current, and power factor.
Lists the specific fuses used in the MAC 600/E, their types, and ratings.
Details communication protocols, DMX start code, and recommended cable types.
Lists compatible lamps with their power, efficiency, life, color temp, and part numbers.
Provides photometric data such as total luminous flux and center intensity values.
Specifies maximum ambient and surface operating temperatures for the fixture.
Lists available accessories for the MAC 600/E, including flight cases and lens hoods.
General| Brand | Martin |
|---|---|
| Model | MAC 600 |
| Category | Lighting Equipment |
| Language | English |
