Martin MAC Viper Performance User Manual

Service and display messages 33
FAN
LAMP L FAN ERR
Left-hand side lamp cooling fan has stopped running. Lamp is shut down. Error cleared when
fixture is reset.
FAN
LAMP R FAN ERR
Right-hand side lamp cooling fan has stopped running. Lamp is shut down. Error cleared when
fixture is reset.
FBEP
PA N FBAC K ERR
Pan position magnetic indexing system timeout. Fixture is unable to correct pan position (but
pan movement will often still be possible).
FBET
TILT FBACK ERR
Tilt position magnetic indexing system timeout. Fixture is unable to correct tilt position (but tilt
movement will often still be possible).
FOER
FOCUS ERROR
Focus position electrical indexing system timeout.
FRER
FRAM ROT ERR
Framing motor overcurrent or indexing system timeout
FSER
FRAMING1 INS ERR
Framing blade 1 left motor overcurrent.
FSER
FRAMING1 ANG ERR
Framing blade 1 right motor overcurrent.
FSER
FRAMING2 INS ERR
Framing blade 2 left motor overcurrent.
FSER
FRAMING2 ANG ERR
Framing blade 2 right motor overcurrent.
FSER
FRAMING3 INS ERR
Framing blade 3 left motor overcurrent.
FSER
FRAMING3 ANG ERR
Framing blade 3 right motor overcurrent.
FSER
FRAMING4 INS ERR
Framing blade 4 left motor overcurrent.
FSER
FRAMING4 ANG ERR
Framing blade 4 right motor overcurrent.
FTER
FROST ERROR
Frost position electrical indexing system timeout.
G1ER
GOBO W 1 ERR
Gobo wheel magnetic position indexing circuit timeout. Lamp strike disabled to protect gobo
bearings.
IRER
IRIS ERROR
Iris position electrical indexing system timeout.
LAER
LAMP ERROR
The lamp is defective, has exploded, is missing, or the lamp cannot restrike after eight attempts.
Pan and tilt are locked. DMX control is disabled. Fixture reset command in control menus is
disabled.
MAER
MAGENTA ERROR
Magenta position electrical indexing system timeout.
PAER
PA N ERRO R
Pan position electrical indexing system timeout.
PSER
PAN SENSOR ERROR
Fixture unable to retrieve reliable data from pan position sensor.
PTCM
P/T SENSOR CAL
Pan/tilt sensors are not calibrated.
PTTC
PT TEMP CUT OFF
Pan/tilt PCB temperature too high. Thermal cutoff activated. Lamp is shut down, fans set to max.
Error cleared when fixture is reset.
PUTC
PSU TEMP CUT OFF
PSU temperature too high. Thermal cutoff activated. Lamp is shut down, fans set to max. Error
cleared when fixture is reset.
R1ER
GOBO W 1 ROT ERR
Gobo wheel gobo rotation magnetic indexing circuit timeout.
Short code
Long message and explanation
Table 4: Error messages

Martin MAC Viper Performance Specifications

General

Brand	Martin
Model	MAC Viper Performance
Category	Lighting Equipment
Language	English