6
LAMP ON
In “lamp on” mode, the lamp stays on and drum rotation is sound activated. If
there is no sound, drum rotation stops.
FLASH
In “flash” mode, both the lamp and rotation are sound activated. If there is no
sound, the lamp turns off after 5 seconds. There is no difference between the 2
“flash” positions.
FUSE REPLACEMENT
1 Disconnect the fixture from AC power.
2 Remove the fuse holder - located next to the power cord - with a flat-tip
screwdriver.
3 Replace the fuse with one of the same size and rating. The rating is shown on
the serial number label.
4 Replace the fuse holder.
TROUBLESHOOTING
If these remedies do not solve the problem, contact your Martin dealer for service.
problem probable cause(s) suggested remedy
No light
No power to the fixture Check connections
Blown fuse Replace fuse
Burned out lamp Install new lamp
Fixture to hot Allow to cool
Improve air flow around fixture
No action
Sound too low to activate
control circuit
Increase volume
Move speakers closer
Electrical malfunction Refer to service technician
Fuse blows repeatedly Electrical malfunction Refer to service technician
To Next Page
Loading...
