3. The Trimmer weight should be evenly distributed between the
arms. The trimmer head should be near and parallel to the ground.
4. Accelerate and hold the engine at cutting speed before entering the material to be cut.
5. Always release the throttle trigger and allow the engine to return to idle speed when not cutting.
6. Stop the engine when moving between work sites.
・
If the trimmer head becomes jammed, stop the engine immediately.
・
Make certain all moving parts have stopped and disconnect the
spark plug before inspecting the equipment for damage.
・
Never use a unit that has a chipped, cracked or broken trimmer head.
・
Snap the strap hook into the ring on the drive shaft. To detach
the strap quickly from the unit, pull upward on red band.
Cutting with Nylon Trimmer Line
・
The tip of the line does the cutting. The line should stay
extended while cutting.
・
Do not force the line into the material. Forcing the line
will cause it to slap against the material, increasing line
usage and causing poor cutting results.
5
WARNING
POTENTIAL HAZARD
・Use of improper line could cause line to break and be thrown in operator’s or bystander’s
direction.
WHAT CAN HAPPEN
・Use of improper line could result in serious personal injury.
HOW TO AVOID THE HAZARD
・Use only good quality, commercial grade, weld resistant trimmer line with a diameter of 2,4mm.
・Do not use any type of wire or other string-like substance. Do not use metal-reinforced line.
Stra
To Next Page
Loading...
