- 16 -
If idle speed adjustment is necessary, and after adjustment the cutting attachment rotates or the
engine stalls, stop using the Multi-cutter immediately!
Contact your local authorized MARUYAMA Dealer for assistance and servicing.
Operation
MC-S(Multi-Cutter with String Trimmer Attachment)
Operating Position
Before using the Multi-Cutter with String Trimmer Attachment, check the following:
Before using the Multi-Cutter with String Trimmer Attachment, check the following:
1. The unit may be on the operator’s right side. The operator’s right
hand should be holding the shaft grip, with his or her fingers on
the throttle trigger. The right arm should be slightly bent.
2. The left hand should be holding the loop handle with the fingers
and thumb fully enclosed around the grip. The left arm should
be extended. Reposition the loop handle up or down the
driveshaft if necessary for a comfortable position.
WARNING
POTENTIAL HAZARD
・Without the shoulder hanging strap installed, the Brushcutter blade can produce side thrust
which can expose the operator and bystanders to blade contact.
・If the Multi-Cutter is not correctly positioned on the operator’s right side, the blade can produce side
thrust which can expose the operator and bystanders to blade contact.
WHAT CAN HAPPEN
・Contact with the Brushcutter blade can cause severe personal injury.
HOW TO AVOID THE HAZARD
・Never operate the Multi-Cutter without installing and using the shoulder harness/strap.
・Always operate the Multi-Cutter with the unit on your right side.
WARNING
POTENTIAL HAZARD
・Foreign objects can be thrown by the Multi-Cutter.
WHAT CAN HAPPEN
・Contact with thrown objects can cause personal injury.
HOW TO AVOID THE HAZARD
・Never operate the Multi-Cutter without the blade guard in place.
CAUTION
・
Read the Safety instructions beginning on page 2 concerning proper use of the Multi-Cutter.
・
Always wear gloves and protective clothing when operating the Multi-Cutter.
Shoulder Hanging Strap
To Next Page
Loading...
