- 29 -
MC-T(Cultivator Attachment)
Lubrication
Maintenance Interval
The Cultivator gearcase should be inspect after each 25 hours of use.
Lubrication
The Cultivator gearcase holds 40g of lubricant. A grease fitting is
located in the top of the gearcase. Lubricant should be checked at
least every 25 hours of operation. Use a#2 lithium-based
lubricant with Molybdenum additive.
General Cleaning and Tightening
The MARUYAMA Multi-Cutter will provide maximum performance for many, many hours if it is maintained
properly. Good maintenance includes regular checking of all fasteners for correct tightness, and cleaning
the entire machine.
Storage
For long term storage of the Multi-Cutter:
1. Empty the fuel tank into a suitable fuel storage container.
2. Run the engine to remove any fuel that may remain in the carburetor.
3. Perform all regular maintenance procedures and any needed repairs.
4. Remove the spark plug and squirt a very small amount of engine oil into the cylinder.
WARNING
POTENTIAL HAZARD
・When engine is running, attached tool and other parts are moving.
WHAT CAN HAPPEN
・Contact with moving tool or other moving parts could cause serious personal injury or death.
HOW TO AVOID THE HAZARD
・Always turn off your Multi-Cutter before you clean or perform any maintenance on it.
CAUTION
POTENTIAL HAZARD
・Oil may squirt out of the spark plug opening when you
pull the starter grip.
WHAT CAN HAPPEN
・Oil can cause eye injuries.
HOW TO AVOID THE HAZARD
・Protect your eyes and keep your face away from the
spark plug opening.
Grease Fitting
for Gearcase
To Next Page
Loading...
