Maruyama MC2600RS - Troubleshooting; Specifications

- 30 -
5. Pull the starter grip once.
6. Reinstall the spark plug.7. Store the Multi-Cutter in a dry place away from excessive heat, sparks or open
flame.
Troubleshooting
Problem Cause Action
Engine will not start
・STOP switch set to off position
・Empty fuel tank
・Primer bulb wasn’t pushed enough
・Engine flooded
・Move switch to on position
・Fill fuel tank
・Press primer bulb until fuel flows
through fuel return line
・Use warm engine starting procedure
Engine will not Idle
・Idle speed set incorrectly ・Set Idle speed
Engine lacks power or
stalls when cutting
・Throttle wire has come loose
・Dirty air filter
・Tighten throttle wire
・Clean or replace air filter
If further assistance is required, contact your local authorized MARUYAMA service dealer.
Specifications
MC2600RS With
MC-S MC-E MC-HT MC-HTS MC-PS MC-T
Weight ※1
5,0 kg 5,6 kg 6,5 kg 6,6 kg 6,0 kg 6,8 kg
Engine Displacement 25,4 cm
3
Fuel Tank Capacity 0,6 litre
Carburetor Diaphragm Type
Ignition System Solid State
Spark Plug NGK BPMR6Y
Fuel Mixture Two cycle Oil Mix 25:1 Ratio
※1. Dry weight without Cutting Attachment, harness and fuel.