- 28 -
MC-HT/MC-HTS(Hedge Trimmer Attachment)
Adjusting Cutting Blades
Maintenance Interval
Before operating the Multi-Cutter with Hedge Trimmer Attachment it is necessary to check the adjustment
of the cutting blades. Blades that are too loose may vibrate, and will not provide a clean, smooth cut.
Cutting Blades Maintenance
CAUTION-BLADES THAT ARE TOO TIGHT CAN CAUSE OVERLOADING WHICH MAY DAMAGE
THE EQUIPMENT.
To adjust the cutting blades, refer to the illustrations and locate
the tension screws.
Loosen the tension screw lock nuts. Gently turn the tension
screws in until sung, then turn the tension screws back out the
lock nuts. Liberally coat the cutting blades with light oil. Start
the engine and operate the Multi-Cutter with Hedge Trimmer
Attachment at full speed for at least one minute. Stop the
engine, and when the blades are motionless, touch the blades
with your hand.
The blades may be warm, but if they are too hot to touch,
loosen the tension screws 1/8 turn.
Lubrication
Maintenance Interval
・The gearcase and angle drive should be inspect after each 10 to 20 hours of use.
・Cutting blades should be lubricated at all times.
Lubrication
The gearcase and angle drive should be checked for lubrication
after each 10 to 20 hours of use. Grease fittings are installed
into both components. Use #2 lithium-base bearing lubricant.
Lubrication of the cutting blades should be maintained at all
times. Use a light oil (#10wt.).
To Next Page
Loading...
