- 21 -
6. Always release the throttle trigger and allow the engine to return to speed when not cutting.
7. Stop the engine when moving between work sites.
・
If the cutting blades becomes jammed, stop the engine immediately.
・
Make certain all moving parts have stopped and disconnect the spark plug before inspecting the
equipment for damage.
・
Never use a unit that has chipped, cracked or broken blades.
IMPORTANT: The thickness of branches which may be cut using this trimmer is limited to up to
approximately 4.5mm. Never try to cut branches thicker than this, as doing so may
result in damage to the trimmer.
8. When transporting the Hedge Trimmer always fit the blade sheath.
Adjusting the angle of the blades [MC-HTS]
Note: Never use the unit if blade angle is not from 48 degree upwards to 84 degree downward.
1. First stop the engine. Next attach the blade cover.
2. Turn the clamp knob counter clockwise until the clamp knob stops.
Angle adjustments are not possible without completely loosening the clamp knob.
3 Always hold the handle when adjusting the blades. The blades adjust from a 48 degee upward angle to an 84
degree downward angle. Never push the lock lever when adjusting the angle of the blades.
4. After you have adjusted the angle of the blades tighten the clamp knob firmly and fix the gearcase in place.
When tightening the clamp knob, make sure both racks engage.
Folding procedure
1. First stop the engine. Next attach the blade cover.
2. Turn the clamp knob counter clockwise until the clamp knob stops. Folding the unit is not possible without
the clamp knob completely loosened.
3. Hold the handle securely , and then fold the blades approximately 180 degrees while pushing the lock lever to
downward. Do not touch the lock lever except when folding the blades.
4. After folding the unit, tighten the clamp knob firmly and fix the gearcase. When tightening the clamp knob make
sure that both racks are engaged.
CAUTION
・ Do not touch the sharpened edges of the cutting blades. The cutting blades are extremely
sharp and dangerous. Always wear gloves to help protect your hands and fingers from injury.
・Do not hold any part other than the handle when adjusting the angle of the blades.
・Stop the engine and set the blade cover when adjusting the angle of the blades.
Down To 8
To Next Page
Loading...
