60
Steps during storage
For a conventional battery, check electrolyte level every month. If the fluid level
is low, replenish it with distilled water or pure water to the highest level mark.
(Never use electrolyte or tap water)
Insufficient battery power may cause difficulty in engine starting. If this occurs,
immediately recharge the battery for 15-20 hours.
When a battery has whitened plates, and if it cannot be restored even after
recharging, it means the service life has come to an end.
Steps for returning a stored bike to service;
1.
Clean the entire motorcycle.
2.
Remove the spark plug and rotate the engine for several turns, before
reinstalling the spark plug.
3.
Reinstall the battery.
Note：
Make sure to connect the positive connector before the negative one.
4.
Adjust tyre pressures
5.
Lubricate all parts that require lubrication according to the manual.
6.
Conduct "Check before driving" instructions as contained in the User
manual.
To Next Page
Loading...
