Masport Monaco - Operating Instructions; Lighting and Running the Fire

OPERATINGINSTRUCTIONS
DONOTPLACEARTICLESONORAGAINSTTHISAPPLIANCE.
DONOTUSEORSTOREFLAMMABLEMATERIALSNEARTHISAPPLIANCE.
DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN
OPERATION.
LIGHTINGANDRUNNINGTHEFIRE:-
•Openthegassupplyvalvebehindtheappliance,iffitted.
CAUTION:Ifthemainburnerhasbeenalight,waittwotothreeminutestoallowittocoolbeforere-
lightingit.
ACCMODELS:-
Thesecanbeinthreeconfigurations.Theymaybeusedassupplied,ortheymaybefittedwitheithera
battery operated wall-mounted thermostat which is wired directly to the heater, or a thermostat
containedinaportableremotecontrol.Withthelatteroption,areceiver ismountedonthestove
pedestal(oneitherside,attherear,facingforward)tosensethesignalfromtheremotecontrol.The
remotecontrolisbatterypowered,andthereceiverrequiresa240vACpowersource.(Instructions
forfittingtheseoptionalthermostatsaresuppliedwiththem.)
LIGHTINGTHEPILOT(ACCmodels):-Note:Toavoidtheriskofbackburning,donotattempttore-
lightthefirelessthanthreeminutesafterithasbeenextinguished.
TheprocedureforlightingthepilotisthesameforallthreeACCversions—
•TurntheHI-LOcontrolknobfullyanti-clockwisetotheHIposition.PushdownandturnthePILOT
controlknobanti-clockwisetothe‘PILOT’position.PressandholdthePILOTcontrolknobdown
firmly.Thebatteryigniterwillgenerateacontinuoussparkacrosstheterminalsatthepilotlight.It
maybenecessarytoholdthecontrolknobdownforsometimebeforethepilotignitesifthereisairin
thepilotlightpipeline.IfthereisnosparkwhenthecontrolknobishelddowninthePILOTposition,
check thebattery in theignitionmodule. It is mounted underthecoverofthesmallblack plastic
housingmountedonthebackoftheheater.OneAAalkalinecellisrequired.
•Keepholdingthecontrolknobdownfor15secondsafterthepilotignites.Releasethepressureonthe
controlknob–thepilotshouldremainalightwhentheknobrises.
•Turnthecontrolknobfullyanticlockwisetothe‘ON’position.Notethatthemainburnerwillnotlight
untilatleastthirtysecondsafterthepilotislit.
TURNINGONTHEMAINBURNER(ACCmodels):-
Whennothermostatisfitted–
•Pushdownandturnthecontrolknobfullyanticlockwisetothe‘ON’positionandthefirewilllightat
fullheat.Theremaybeastrongsmellthefirsttimethelogsarefiredbutthiswillsoondisappear.
Whenthewallmountedprogrammablethermostatisfitted–
Firstensurethatgoodbatteries(3xAAalkaline)arefittedinthewallthermostat,thattheslideswitch
behindthehingedbottomcoverissetto‘HEAT’,andthatthetemperaturesettingonthethermostatis
abovetheprevailingroomtemperature.Fulldetailsofthewall-mountedthermostatandprogramming
instructionsaresuppliedwithit.
•Turnthecontrolontheheaterfullyanticlockwisetothe‘ON’positionandthefirewilllightatfullheat.
Theremaybeastrongsmellthefirsttimethelogsarefiredbutthiswillsoondisappear.
WhentheIRRC300portableremotethermostatisfitted–
Firstcheckthatgoodbatteriesarefittedintheremotecontrol.Tofitbatteries(twoAAAalkaline),
slidethecoverbelowthedisplayinthedirectionofthearrowandpullitfurtherinthesamedirection
firmlyuntilitdisengages.Ensurethatthereceiverhasavalid230voltACsupply.
•Movetheswitchonthereceivercontrolbox(attherearofthepedestal)to‘REMOTE’.(Seepage5,
RECEIVERSWITCHPOSITIONS).
2