electric ratings. Measuring leads must be in good condition.
1.2 DURING USE
·
·
·
·
·
Never exceed the protection limit values indicated in specifications for each range
of measurement.
When the meter is linked to a measurement circuit, do not touch unused terminals.
When the value scale to be measured is unknown beforehand, set the range
selector at the highest position.
Before rotating the range selector to change functions, disconnect test leads from
the circuit under test.
When carrying out measurements on TV or switching power circuits, always
remember that there may be high amplitude voltage pulses at test points, which
-2-
To Next Page
Loading...
Need help?
General
