INSTALL THE HEADER BRACKET
model no. 046-0265-2 | contact us 1-800-689-9928
18
INSTALL THE HEADER BRACKET
Mark the Door Centerline
Close the door from inside the garage and mark the vertical centreline of the door on the wall
and the top door panel.
Sectional Door
One-piece Jamb Door
WARNING
• Header bracket must be secured to structural supports. If appropriate support does not exist, install a
new support using 2x4 board on drywall or between 2 studs with lag screws (not included). DO NOT
install header bracket over drywall.
• Concrete anchors must be used if mounting header bracket or 2x4 into masonry.
• Always call a trained door systems technician if garage door binds, sticks, or is out of balance. An
unbalanced garage door might not reverse when required.
To Next Page
Loading...
Need help?
General
