WARNING
To prevent possible serious injury or death:
• Never allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
Battery Disposal:
• Please dispose the used battery per municipal or provincial law.
Battery Replacement
All remotes come with battery installed. To
replace the battery, follow the instructions
below.
It is time to change the battery when the red
LED light on the remote does not turn on when
either button is pressed.
Lithium battery CR-2032 included (positive side up).
To replace the battery:
1. Undo the two screws on the back of the remote. The bottom case will then come off.
2. Take out the old battery.
3. Place the new battery in position.
4. Close the cover and reinsert two screws.
Install Keypad and Battery
Undo the screw on the bottom side of the keypad.
Remove the back plate.
Insert a AAA battery (1.5 V Alkaline type).
Mount the back plate with the mounting accessories.
Attach the keypad on the back plate and tighten the screw on the bottom of the keypad.
To Next Page
Loading...
Need help?
General
