CONNECT THE OPENER TO POWER
Connect AC Power
Plug motor unit into grounded outlet. If a grounded outlet
is not available, contact a qualified electrician to install
a proper outlet. DO NOT ACTIVATE THE OPENER UNTIL
INSTRUCTED.
Permanent Wiring/Remove Cover
Be sure the power cord is unplugged. Remove the screws
from the cover of the opener.
Permanent Wiring -
Remove the Power Cord
WARNING
If permanent wiring is required by your local code, have a licensed electrical contractor follow
the procedures outlined in this manual. Disconnect power to the circuit before removing
cover.
• Be sure power is not connected to the opener and disconnect power to circuit before
removing cover to establish permanent wiring connection.
• Garage door installation and wiring must be in compliance with all local electrical and
building codes.
• Never use an extension cord, 2-wire adaptor, or change plug in any way to make it fit
outlet. Be sure the opener is grounded.
• The opener has a grounded type plug for your protection and only fits into a grounding
type outlet. Do not change the plug in any way.
To Next Page
Loading...
Need help?
General
