28
3. Hold the workpiece firmly against
the mitre gauge, with the path of
the blade in line with the desired
cut location. Keep the workpiece
approximately 1” (2.5 cm) in front
of the blade. KEEP BOTH HANDS
ON THE MITRE GAUGE, AWAY
FROM THE BLADE AND THE PATH
OF THE BLADE.
4. Start the saw motor, and allow the
blade to come up to speed.
5. While using both hands to keep the workpiece against the face of the mitre
gauge and holding the workpiece flat against the table, slowly push the
workpiece through the blade.
6. NEVER try to pull the workpiece back with the blade turning. Turn the
switch off, allow the blade to stop, and carefully slide the workpiece out.
BEVEL CROSSCUTTING (Refer to Fig. 27)
This operation is the same as
crosscutting, except that the bevel
angle is set to an angle other than
0°. Refer to Fig. 27 for proper hand
positioning.
WARNING! To reduce the risk of in-
jury, turn the saw off and disco
nnect it
from the power source before install-
ing and removing accessories, before
adjusting or changing set-ups, or when
making repairs. An accidental start-up
can cause injury.
WARNING! Use caution when starting the cut in order to prevent
binding
of the guard against the workpiece, resulting in damage to saw and possible
personal injury.
WARNING! Before connecting the table saw to the power source o
r oper-
ating the saw, always inspect the guard and spreader for proper operation,
alignment, and clearance from the saw blade. Check the alignment after each
change of bevel angle.
Fig. 26
Fig. 27
To Next Page
Loading...
