Cleaning NC-3000
Cleaning the cover of NC-3000
Occasionally clean NC-3000 as follows:
Prepare a mixture of a gentle kitchen-use detergent (one that does not
contain abrasive powder or strong chemicals such as acid or alkaline.) Use 5
parts water to 1 part detergent.
Absorb the diluted detergent into a sponge.
Squeeze excess liquid from the sponge.
Wipe the cover with the sponge, use a circular motion and take care not to let
any excess liquid drips into the interior of the device.
Wipe the surface to remove the detergent.
Rinse the sponge with clean running water.
Wipe the over with the clean sponge.
Wipe the surface again with a dry, soft lint-free cloth.
Wait for the surface to dry completely and remove any fibers.
Cleaning the bill path of NC-3000
Open the upper bill path.
Gently wipe it or dust the bill path with a MA brush or a dry, soft lint-free cloth.
If stains remain, moisten a soft, lint-free cloth with water or a 50-50 mixture
of isopropyl alcohol and water that does not contain impurities.
Wring out as much of the liquid as you can.
Wipe the bill path and the sensor surface again; do not let any liquid drip into
the device.
*NOTE: Avoid spraying cleaner directly on the device, and be sure to day the bill
path before closing it.
To Next Page
Loading...
Need help?
General