147
146
10.5 TV PROGRAMMING INSTRUCTIONS (ID MARKET) - WITH THE THE HAUPPAUGE TV TUNER
CHAPTER 10: CLIMB MILL SPECIFICATIONS AND ASSEMBLY GUIDE
Once the cardio equipment has been installed and propered power and cable wiring is provided, The Television must be programmed to the club's
channels and settings.
AutoTuning - An auto scan will search for channel signals from the coax cable. It will tune in all channels which provide a signal of sufficient
strength.
1. Press ENTER, 1, 0, 0, 1, ENTER on the number keypad to enter Manager Mode.
2. Press TV on the screen (Figure A).
3. Select the tuner type on the screen (Figure B).
4. Select the source on the screen (Figure C). If your source is digital, select DVBT and continue onto Steps 5-6 for TV programming. If your source
is analog, select Analog and skip to the Steps 7-9 for TV programming.
5. Press Start Scan to begin scanning (Figure D).
6. Scan Started will be displayed on the bottom left hand corner of the screen (Figure E). Once the channel scan is complete, the scanned channels
will be displayed on the channel list on the screen (Figure F).
FIGURE BFIGURE A
FIGURE C
FIGURE D
FIGURE E
FIGURE F
10.5 TV PROGRAMMING INSTRUCTIONS (ID MARKET) - WITH THE HAUPPAUGE TV TUNER - CONTINUED
CHAPTER 10: CLIMB MILL SPECIFICATIONS AND ASSEMBLY GUIDE
AutoTuning(continued):
7. Select the Analog source on the screen (Figure G). Select your country location (Figure H).
8. Select the signal delivery type on the screen (Figure I). Select the tuner type on the screen (Figure J).
9. Press Start Scan to begin scanning (Figure K). Scan Started will be displayed on the bottom left hand corner of the screen (Figure L).
FIGURE JFIGURE I
FIGURE HFIGURE G
FIGURE LFIGURE K
To Next Page
Loading...
Need help?
General
