149
148
CHAPTER 10: CLIMB MILL SPECIFICATIONS AND ASSEMBLY GUIDE
AutoTuning(continued):
10. The achieved scan will be displayed on the bottom left hand corner of the screen (Figure M). Once the channel scan is complete, the
scanned channels will be displayed on the channel list on the screen (Figure N).
FIGURE NFIGURE M
10.5 TV PROGRAMMING INSTRUCTIONS (ID MARKET) - WITH THE HAUPPAUGE TV TUNER - CONTINUED
10.5 TV PROGRAMMING INSTRUCTIONS (ID MARKET) - WITH THE AVERMEDIA TV TUNER
CHAPTER 10: CLIMB MILL SPECIFICATIONS AND ASSEMBLY GUIDE
Once the cardio equipment has been installed and proper powered and cable wiring is provided, The Television must be programmed to the club's
channels and settings.
AutoTuning - An auto scan will search for channel signals from the coax cable. It will tune in all channels which provide sufficient signal.
1. Press ENTER, 1, 0, 0, 1, ENTER on the number keypad to enter Manager Mode.
2. Press TV on the screen (Figure A).
3. Select the tuner type on the screen (Figure B).
4. Select the source on the screen (Figure C). If your source is digital, select DVBT and continue onto Steps 5-7 for TV programming. If your
source is analog, select Analog and skip to Steps 8-11 for TV programming.
5. Select your country location on the screen (Figure D).
6. Press Start Scan to begin scanning (Figure E). Scan Started will be displayed on the bottom left hand corner of the screen (Figure F).
FIGURE BFIGURE A
FIGURE FFIGURE E
FIGURE C
FIGURE D
To Next Page
Loading...
Need help?
General
