Matrix C7xi-03 - Page 78

151
150
CHAPTER 10: CLIMB MILL SPECIFICATIONS AND ASSEMBLY GUIDE
AutoTuning(continued):
7. The scanning progress will be displayed on the bottom left hand corner of the screen (Figure G). Once the channel scan is completed, the
scanned channels will be displayed on the channel list on the screen (Figure H). The scan process is now completed with non-Analog signal.
FIGURE HFIGURE G
10.5 TV PROGRAMMING INSTRUCTIONS (ID MARKET) - WITH THE AVERMEDIA TV TUNER - CONTINUED
8. If you would like to change some channel sequence, select a channel from channel list and go to channel order settings. Tap or click UP/
DOWM ARROW button to move the channel order (Figure I).
FIGURE I
AutoTuning(continued):
9. Select the Analog source on the screen (Figure J). Select your country location (Figure K).
10. Select the signal delivery type on the screen (Figure L). Select the tuner type on the screen (Figure M).
11. Press Start Scan to begin scanning (Figure N). Scan Started will be displayed on the bottom left hand corner of the screen (Figure O).
FIGURE KFIGURE J
FIGURE MFIGURE L
10.5 TV PROGRAMMING INSTRUCTIONS (ID MARKET) - WITH THE AVERMEDIA TV TUNER - CONTINUED
CHAPTER 10: CLIMB MILL SPECIFICATIONS AND ASSEMBLY GUIDE
FIGURE N
FIGURE M
FIGURE O