117
9.23 TESTING THE SUSPENSION ELLIPTICAL
ONCE THE UNIT OR REPLACEMENT PART IS FULLY INSTALLED AND ASSEMBLED AND
PROPERLY PLACED ON THE FLOOR, USE THE FOLLOWING INSTRUCTIONS TO TEST
THE MACHINE:
1) Enter Service Mode (ENTER, 3, 0, 0, 1, ENTER) and input the serial number of the console. Also set the Machine Type (ENTER, 3, 0, 0, 2,
ENTER) and verify that the Date and Time are correct (See Section 7.2). NOTE: If he Machine Type setting has been changed, the unit power
should be reset. Cycle the power switch.
2) Enter Service Mode (ENTER, 3, 0, 0, 1, ENTER). Then edit Club ID on the Asset Management and Root Path on the Virtual Active
depending on whether the club has these functions.
3) Program the TV channels as outlined in Section 10.5.
4) Without hitting start or entering any exercise modes, stand on the machine and hold the handlebars while initiating movement to simulate
exercising. While moving listen for any odd noises or squeaks.
5) After stopping movement, press the green GO key and begin using the machine.
6) Grasp the hand grips to check for proper heart rate response.
7) Press the LEVEL UP and DOWN keys both on the hand grips and on the console to make sure resistance is fully functional.
8) If everything functions properly, stop pedaling and the unit will reset to normal operation after 30 seconds.
CHAPTER 9: PART REPLACEMENT GUIDE
To Next Page
Loading...
Need help?
General
