164
CHAPTER 11: SOFTWARE UPGRADE INSTRUCTIONS
11.2 SOFTWARE UPGRADE PROCEDURE FROM USB
FIGURE A FIGURE B
NOTE:Don’tpoweroffthemachinewhilethesoftwareisbeinginstalled.Afterthesoftwarehasbeen
installedcompletely,turnoffthemachineandwait30seconds,thenturnthemachinebackon.Ifthedisplay
shows04A0,turnoff&turnonthemachineagain.
1) Copy the software onto the USB drive (Figure A).
2) Turn on the power to the Elliptical, wait until the welcome display picture has come up (Figure B).
3) Enter Manager Mode by pressing ENTER, 1, 0, 0, 1, ENTER on the lower keypad.
4) Record the Accumulated Mileage, Accumulated Time, and Serial Number. NOTE: The information can be lost during the update procedure
and should be recorded so that the information can be entered into the newly updated console.
5) Press the HOME key to return to the welcome display picture.
6) Enter Update manager by pressing ENTER, 3, 0, 0, 4, ENTER on the lower keypad.
7) Insert the USB Drive into the USB port in the console (Figure C).
8) Press the Settings key on the screen. Then select the update source (Figure D).
FIGURE C FIGURE D
To Next Page
Loading...
