Mattei BLADE 1 - Operation

1-5
TI015G0013
BLADE 1-2-3
The following safety precautions dene
both the behaviour and obligations to be
observed when carrying out the activities
listed in the manual, the instructions for
the machine use and how to operate it
under safe conditions, for the sta and the
surrounding environment.
Machinery Directive
Machinery Directive means the 2006/42/EC
DIRECTIVE OF THE EUROPEAN PARLIAMENT
AND COUNCIL dated 17 May 2006.
Machine
Machine means the functional assembly
composed of: control unit, processing
unit, working and resting equipment,
systems (electrical, pneumatic, hydraulic,
cooling, lubrication systems) and any group
completing the system functionality.
Working area
Working area means the protected volume
limited by guards to prevent injuries and
aimed at operation during the machine
processing.
Authorized sta
Authorized sta means personnel duly
trained and appointed to perform the
activities listed below and that make up the
operating instructions for the machine.
Appointed sta
Appointed sta means the personnel who,
although not participating materially in
the work, supervise the work of others, for
example the responsible engineer.
Transport
Transport means all those operations
regarding the handling of the machinery or
part of it.
Installation
Installation means the mechanical, electrical
and uid system integration of the machine
into a production reality, in compliance with
specied requirements.
Commissioning
Commissioning means the functional check
of the machine installed.
Operation
Operation means the operating mode at
which the machine produces compressed
air according to all settings and controls
inserted by the control device.
Decommissioning
Decommissioning means to disconnect
mechanically and electrically the machine
from a production line.
Dismantling
Dismantling means dismantling and
eliminating the machine components.
Maintenance and repair
Maintenance and repair means the regular
check and/or replacement of parts or
components of the machine and any action
to identify the cause of failure, ending
with the machine resetting to the design
operating conditions.
Only authorised personnel should carry
out maintenance, troubleshooting and
repairs. Any maintenance and repair in
progress should be signalled by a specic
sign, stating the maintenance condition and
placed on the control panel until completion
of the job, even if temporarily interrupted.
All operations for installation, maintenance
or replacement of components on the
machine or on the control unit should be
performed with the system switched o.
Therefore, the main switch should be on OFF
(OPEN) position and blocked with the safety
lock to prevent any movement to the ON
position.
Before acting, people in charge of
General information