Mattei BLADE 1 - General Notes on Delivery; Final Inspection

1-4
TI015G0013
BLADE 1-2-3
MANUFACTURER’S IDENTIFICATION
DATA  “CE MARKING”
Ing. ENEA MATTEI S.p.A. is identied as
the machine’s manufacturer, according to
current laws in force, by following acts:
– Declaration of conformity
– CE marking
– Instruction manual
A specic plate on the machine gives the
following indelible information on the CE
MARKING:
Model
Code
Serial number
Year of manufacture
Flow rate
Pressure
Power
Rated speed
Dryer
Receiver capacity
Weight
Manufacturer’s name
and address
The “CE MARKING” plate is applied on the
command panel or on the bodywork.
The relevant “DECLARATION OF
CONFORMITY” is enclosed.
It is forbidden to remove the “CE MARKING”
plate and/or exchange it with other plates of
machines of the same model in use by the
customer or the operator.
Should the “CE MARKING” plate be
accidentally damaged or removed from
the machine, customer should inform the
company.
GENERAL NOTES ON DELIVERY
Upon receipt of the machine please check
that:
The supply complies with the order
specication.
There are no damages due to transportation
or other reasons.
(In the event of damage or missing parts,
please inform immediately and in detail
the forwarding agent or Ing. ENEA MATTEI
S.p.A.).
F
NOTE
ALWAYS STATE THE MACHINE
SERIAL NUMBER AS WELL AS
THE PRINT NUMBER IN THE FOOTER
OF THIS MANUAL WHEN MAKING ANY
REQUEST TO Ing. ENEA MATTEI S.p.A. OR
ONE OF THEIR SERVICE CENTRES.
FINAL INSPECTION
The manufacturer carries out the nal
inspection of the machine directly, during
the production phases, in compliance with
the company quality system.
Ing. ENEA MATTEI S.p.A. is responsible for the
machine under its original conguration.
Ing. ENEA MATTEI S.p.A. refuses any
responsibility for improper use of the
machine, for damages due to operations
which are not described in this manual or
unreasonable applications.
SAFETY PRECAUTIONS
The nal user should comply with the
instructions given by the supplier,
concerning:
– safety devices already installed on the
machine
– instructions for correct machine
installation
– correct use and periodic maintenance of
all the machine components, including
safety devices
– regulations of current laws
General information