Mattei BLADE 1 - Purpose of Document

1-2
TI015G0013
BLADE 1-2-3
PURPOSE OF DOCUMENT
This manual includes technical
characteristics, performance, transportation
and installation rules, instructions for use,
preventive and corrective maintenance
operations of the machine manufactured by
Ing. ENEA MATTEI S.p.A.
F
NOTE
This manual should be
considered an integral part
of the machine, and should stay with it
during the whole life of the equipment.
Keep the manual and all attached
documents in a place easily accessible
to all sta in charge of the control or
maintenance of the machine.
Ing. ENEA MATTEI S.p.A. reserves the
right to subject the supply of further
copies to the repayment of charges and
to acceptance of special clauses related to
the selfdefense of intellectual property,
patent, and executive and functional
identity of the product and/or parts of it.
It is understood that passing on all or
part of this manual to third parties is not
allowed without prior written consent of
Ing. ENEA MATTEI S.p.A., either texts, or
illustrations or diagrams.
Ing. ENEA MATTEI S.p.A. reserves the right
to make changes without prior notice.
Any change, addition or elimination
of machine elements, components,
functions or cycles, not previously agreed
upon with Ing. ENEA MATTEI S.p.A.
releases the manufacturer from any
responsibility whatsoever.
This manual is for the machine user and
service engineer, and it aims at supplying
them with typical system technical data,
with a technical description of the various
operating groups composing the same as
well as the essential use procedures and
information needed to perform preventive
and corrective maintenance.
The manual is intended for sta with a sound
knowledge of the machining processes,
of mechanical and electrical diagrams,
and involves both machine operators and
technical service engineers.
This manual is an integral part of the
machine and contains information that aims
at granting all sta safe working conditions
and ensuring perfect eciency during the
whole life of the machine.
For a correct use of the machine it is assumed
that the working environment complies
with current regulations concerning safety
and health.
APPLIED DIRECTIVES AND TECHNICAL
STANDARDS
The machine has been designed,
manufactured and tested in compliance
with the “safety and health essential
requirements” stated in attachment 1 to the
European Directive 2006/42/EC.
The list below gives the reference standards
used by Ing. ENEA MATTEI S.p.A. for the
design, manufacture and testing of the
machine.
LIST OF HARMONIZED DIRECTIVES AND
TECHNICAL STANDARDS
– Machines directive 2006/42/EC
– Electromagnetic compatibility
directive 2004/108/EC
– Low voltage directive 2006/95/EC
– EN 1012-1
Compressors and Vacuum Pumps – Safety
Requirements - Compressors
General information